The Failure Test

Despite all the good reasons for focusing on with-trend trading, the first pattern I taught in my book was a little countertrend pattern–the failure test. Why? In this case, the reason is that the pattern is clearly defined, and it’s easier to make concrete rules for things like stop location and trade management. The failure test pattern occurs when a market presses beyond a previous pivot (or other support/resistance area), and then quickly reverses; this is also a variation of a failed breakout.

There are many names for this pattern. Victor Sperandeo immortalized in his excellent books (here and here) as the “2B” pattern, and many other authors have since used that name. Wyckoff used slightly more confusing terminology, calling a failure test below support a spring (prices “spring” back above support) and a failure test below resistance and upthrust. (The latter term is confusing, but prices “thrust above” resistance and immediately failed. Furthermore, if you’re interested in Wyckoff’s work, this little volume is an excellent introduction.) Though there might be some subtle differences implied by these labels, I just call them all failure tests.

Figure 1 - The failure test concept
Figure 1 – The failure test concept

The failure test is a simple pattern. Take a look at Figure 1, which shows a theoretical market bouncing around in between support and resistance. At point A, prices poked above resistance, and immediately failed back below in a classic failure test or Wyckoff upthrust. (Don’t worry about exact triggers or entries at this point, just understand the fundamental concept.) At point B, the market traded briefly below support, and quickly recovered back above, triggering another failure test (or a Wyckoff spring.) Note also that the short trade at A would have probably been very profitable, while a long trade entered at B might have been a loser. It’s always important to build awareness of how patterns can resolve—both for and against the intended direction. In other words, study many examples of losing patterns.

Figure 2. Failure test entry trigger
Figure 2. Failure test entry trigger

The best way to enter these failure test trades is often the simplest. Look for a point where price trades above resistance and immediately fails back below on the same bar, and enter short on that bar’s close with a stop just above the high of that bar. (See figure 2.) It is also possible to enter on the following bar (i.e., a bar closes above resistance, but the next bar reverses and fails back below resistance); in all cases, the stop must go at or just beyond the new high set on the movement. For long entries, simply flip everything to a test below support and close back above.

Conceptually, one of the main reasons markets exist is to create trading activity. Think about that for a minute–markets exist to create trading volume, so they will naturally seek out levels where there may be orders clustered. (This is also tied into the reasons that markets are essentially designed to cause traders to make mistakes.) Many of those forays to find volume will discover nothing more than a few stop orders with no conviction beyond the level. This pattern lets you take this potentially treacherous market tendency (to seek your stops) and turn it to your advantage with a tight entry against a clear risk point.

One final, and perhaps the most important consideration, is risk management. I tend to trade failure tests in two main contexts: in trading ranges, on pure tests of support or resistance; and in trends, as counter-trend entries—essentially an attempt to catch the reversal off the high of an uptrend or the low of a downtrend. Both of these situations are potentially risky: liquidity can be low in trading ranges, so it’s not uncommon to have a gap opening against your positions. In trends, “gap and go” beyond the trend extreme (and, ahem, your stop) is also a possibility, and these are gap openings that do not tend to reverse. You must be prepared to accept larger than expected losses on some subset of these trades, so I suggest trading them on smaller size and risk than most of your other setups. Also, if you have an adverse opening against your position, be prepared to take action, as things often only get much worse as the trading day goes on.

This is a simple and clear pattern that can work for traders and investors on all timeframes. If you are not an avid chartreader, this is also a little pattern that may help you dodge some losses. Say, for instance, you are holding a stock that seems to be running into some trouble. If you watch (or review weekly) the chart, you may see it make an attempt to break out above old highs and fail in a failure test pattern. Though this is where a tactical trader might go short, even if you have no intention of going short you can still take some profits and use the pattern to refine your exit.

This is certainly not the only counter trend pattern in our arsenal, but it’s a useful one and a good place to start.

AdamHGrimes

Adam Grimes has over two decades of experience in the industry as a trader, analyst and system developer. The author of a best-selling trading book, he has traded for his own account, for a top prop firm, and spent several years at the New York Mercantile Exchange. He focuses on the intersection of quantitative analysis and discretionary trading, and has a talent for teaching and helping traders find their own way in the market.

This Post Has 5 Comments

  1. engrdga

    Good post Adam, your post/blog is a very excellent source(s) of trading ideas, keep it up, great…

  2. blackmamba

    Really good post. I often use the failure pattern. Thank you Adam.

    1. Adam Grimes

      Thank you. Yes, I love it too… though it seems we have seen it a bit less often on daily charts lately. Just a reflection of the overall environment, I suppose.

  3. yong

    Great article Adam. If u happen to drop by Singapore, will be keen to meet up with you. -Yong

Comments are closed.